6. Add DESS-keys |
  
|
6. Add DESS-keys |
|
To add a DESS key into the module, use the DESS Post Interface.
6.1. Connect DESS Post Interface to MPI-2 interface and to the diagnostic connector of the vehicle.
6.2. Run the B.U.D.S. program with the privilege PWC Dealer & Sport Boat Dealer.
6.3. Open the tab "Keys" and click on "Erase All keys".
6.4. Confirm your choice.
6.5. Click on the Add Key button. For some vehicles, click on the Add Normal Key or Add Learning Key® button.
6.6. Insert a key on the DESS Post Interface.
| 6.7. Click “OK” and remove key from DESS Post Interface. |
| Repeat steps 6.5. - 6.7. for each key that you want to add. |
6.8. Write MPEM document into the vehicle. Click on “Write Data”.
6.9. Confirm your choice.
6.10. Remove DESS-key from the vehicle post and wait.
After the message disappear, insert the DESS-key again.