B.U.D.S. Chart |
  
|
B.U.D.S. Chart |
|
Please Note: MPI-1 is no longer officially supported in the version of B.U.D.S. 3 and higher.
Ski-Doo
Quick reference chart for selecting the correct MPI – 2 communication tools required for Ski-Doo B.U.D.S. communication and programming.
The VCK (Vehicle Communication Kit) is no longer available. Only the MPI – 2 is available. This chart is intended to show what electrical adapters are required to connect the MPI – 2 to the electrical system of Ski-Doo vehicles. The proper connections will ensure that key programming, diagnostics and module updates are correctly performed with B.U.D.S.
To use this quick reference chart, first identify the vehicle to be programmed. Then reference the marked number in the column and identify the correct tool as listed in the picture section of this document. Note: For connection procedures refer to the appropriate shop manual and/or Service bulletin 2005 – 7.
Note: For chassis identification refer to the chassis section of the appropriate specification booklet or the chassis identification section in the Yellow book.
U = For ECM or cluster Update
K* = – For DESS key programming only
Notice: On the listed vehicles only use the DESS post interface for key programming. If an update of the ECM or cluster is necessary, use the diagnostic cable in its place. !!! Failure to use the diagnostic cable could result in module or cluster damage!!!
NR = Not Recommended
= Connected if not running – Disconnect battery to start vehicle
Notice: When performing any module update ensure that the vehicle or power supply battery is fully charged.
Roadster
ATV
SSV
Sea-Doo / Sports Boat
