B.U.D.S. > User Interface > Document > Faults > Faults Page

Description

The Summary table displays 7 parameters for each fault. Parameters are continuously and automatically updated at a rate of about two times per second. The example below shows the parameters for a battery fault:

Code	State	Module	Count	Cycle Time	Total Time	Description
P0563	Active	ECM				Battery voltage too high

To change the display of the summary table

From the drop down list, select the faults that you want to be displayed in the Summary table. You can choose between:

All Faults

Active Faults

Active and Occured Faults

To clear a particular ECM fault

1.	Select an ECM fault in the Summary table.

2.	Click on the Clear Fault button.

3.	Click on the message box Yes button.

4.	Wait until B.U.D.S. clears the fault into the module.

5.	Perform the ECM tracking procedure.

To clear all occurred faults

1.	Click on the Clear Occurred Faults button.

2.	Click on the message box Yes button.

3.	Wait until B.U.D.S. clears all occurred faults into modules.

4.	Perform the ECM tracking procedure.

Notes

You can not clear an individual MPEM fault with the Clear Fault button.

Clearing a fault resets the Count, Cycle and Total time stamps to zero.

If you clear a fault that has a double star (**) preceding the fault code, then the conditions associated to the fault in the More Details page are also cleared.