Vehicle connection

Navigation:  B.U.D.S. > Hardware > VCK® (unsupported) > Vehicle Connection (VCK®) >

Vehicle connection

 Previous pageReturn to chapter overviewNext page

To connect the MPI® to a vehicle

1.Launch B.U.D.S. and make sure that it detects the MPI.
2.Connect the HDDB-15 male connector of the diagnostic cable to the MPI diagnostic port (engine icon). For safe contact in the connectors, we strongly recommend you to use thumb screws on the DB9 connector to allow for locking the connector to its mating half.
3.Connect the other end of the diagnostic cable to the 6-pin adapter.
4.From the list below, select the vehicle type you want to connect to:
_bm4Personal watercraft equipped with a 717 or a 787 engine
_bm4Personal watercraft equipped with a 947-DI or a 1503 engine
_bm4Personal watercraft equipped with a RFI engine
_bm4Snowmobile equipped with a SDI or a V1004 engine
_bm4Snowmobile MPEM

Note

You can optionally use a diagnostic extension cable between the diagnostic cable and the 6-pin adapter.